Elantas Dolph's

Table transcribed from the manufacturer’s overview.

Technical data sheet on request (PDF)

The products come in 1 kg, 5 kg and 25 kg packs and as a spray.

Table transcribed from the manufacturer’s overview.

Table transcribed from the manufacturer’s overview.

Technical data sheet (PDF) on request

Example of a varnish applied by dipping

The products are available in 1 kg, 5 kg and 25 kg packs

Table transcribed from the manufacturer’s overview.

Technical data sheet on request (PDF)

Example of applying VonRoll varnishes

The products come in 1 kg, 5 kg and 25 kg packs

Table transcribed from the manufacturer’s overview.

Technical data sheet (PDF)

The products come in 1 kg, 5 kg and 25 kg packs

Thinner T-200

FOR THINNING THE VARNISHES

AC41, AC43, BC325, BC346-A, BC359

ENAMEL type

ER41, EB41

Thinner T-352

FOR THINNING THE VARNISHES

BC -352

Available in 1 L, 5 L and 25 L packs

UN 1263 ADR3 CT3

Technical data sheet (PDF)

Available in 5 L and 25 L packs

UN 1263 ADR3 CT3

Technical data sheet (PDF)

REAKTOR RE – 2000

The hardener we generally recommend for curing all our resins and epoxy compounds. For a 500 g mass the pot life is about 1 h at 20 °C.

Curing normally takes 12 h. On humid days, and when the resin layer is thin, the surface may stay slightly greasy.

The greasiness disappears with time. It does not occur if the resin is dried in an oven at 40–50 °C.

REAKTOR RE-2001

A hardener that gives the mass more flexibility than REAKTOR RE-2000.

Recommended for preparing larger quantities of resin, over 4–5 kg. The greater flexibility shows especially when the cured resin is heated: the resin withstands wider temperature variations without damage (without cracking).

The pot life for a 1 kg mass is about 1 hour at 20 °C, and the curing time is ~12 h.

REAKTOR 400-D

A hardener to use when a glossier, grease-free surface is wanted, and on cold, humid days.

It must also be used when the resin layer on the object has to be very thin and the resin cannot be cured in an oven at 50–60 °C. It is used in larger quantities than RE-2000, so it mixes with the resin better and more evenly, and there is much less chance of soft zones remaining in the cured mass because the hardener was not mixed well and evenly with the resin. The pot life for a 500 g mass is 40–45 min at 20 °C.

We advise against using it for more than 600–1000 g of resin.

REAKTOR RE-2013

A hardener that releases fewer volatiles than RE-2000. Recommended for resin that will be poured onto pre-heated objects, or when the resin is handled by people who show signs of allergy or sensitivity to epoxy resins.

On cold, humid days, or with a thin layer, the resin surface may stay slightly greasy. This can be avoided by drying in an oven at 40–50 °C.

The pot life for a 500 g mass is 20–30 min at 20 °C. It is more reactive and cures faster when heat is added. We advise against using it for more than 500–600 g of resin.